Table of Contents
Advertisement
Operating the appliance
en
Control panel model 2
Control panel
Explanation
Fan on/off
%
Switch off the saturation display
#
-
Reduce the fan settings
+
Increase the fan settings/intensive setting 1, 2
Fan run-on time
r
Light on/off/dimming
B
Setting the fan
Switching on the appliance
Press the
button.
%
■
The fan starts at setting
Press the + or - button to change the fan strength.
■
Switching off
Press the
button.
%
■
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Press the + button when the fan is at setting
The intensive boost setting
button again activates the intensive boost
After approx. six minutes, the electronics automatically
reduce the fan to a lower setting . If you want to end the
intensive setting before the preset time expires, press
the - button until the required fan setting is reached.
Fan run-on time
The fan run-on time is possible at every fan setting
(except boost
and boost
‚
Select the desired fan setting and press the
Š
min
r
appears on the display.
Once this time has elapsed, the fan switches off
automatically.
Setting the run-on time
When
min
appears on the display, press the + or -
Š
r
button.
You can set a run-on time of between 1 and 9 minutes.
6
.
ƒ
.
„
is activated. Pressing the +
‚
ƒ
setting.
).
ƒ
button.
r
Lighting
The lighting can be switched on and off independently
of the fan.
Press the
B
button.
Setting the brightness
Press and hold the
B
brightness is reached.
Saturation display
When the metal mesh grease filters or the activated
carbon filter are saturated, a signal sounds for approx.
4 seconds after the fan is switched off.
In addition, the corresponding symbol appears in the
display:
Metal mesh grease filter:
■
Activated carbon filter:
■
If you have not yet done so, the metal mesh grease
filters should be cleaned or the activated carbon filter
changed now.
For instructions on how to clean the metal mesh grease
filters, please refer to the section
.
maintenance
While the saturation displays are flashing, they can be
reset. To do this, press the
Switching over the display for circulating-air mode
For circulating-air mode, the electronic control display
must be switched over accordingly:
The extractor hood must be connected and switched
■
off.
Press the
and
%
r
■
the
display for starter sets for circulating-air mode or
™#
'#
display for CleanAir circulating air modules
lights up.
Repeatedly press the button combination to switch
■
the electronic control display back to exhaust air
mode (
display).
#
Audible signal
Switching on the acoustic signal
When the fan is switched off, press the
buttons at the same time for approx. three seconds. An
acknowledgement signal sounds.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
button until the desired
#
'#
Cleaning and
button.
#
buttons at the same time until
and +
%
Advertisement
Table of Contents
