Table of Contents
Advertisement
Installation
en
The required connection data can be found on the
rating plate inside the appliance; to do this, remove the
metal mesh grease filter.
Length of the cable: approx. 1.30 m
This appliance complies with the EC interference
suppression regulations.
:
Warning
Risk of electric shock!
It must always be possible to disconnect the appliance
from the electricity supply. The appliance must only be
connected to a protective contact socket that has been
correctly installed. If the plug is no longer accessible
once the appliance has been installed, or a fixed
connection is required, the installation must have an all-
pole isolating switch with a contact gap of at least
3 mm. Only an electrician may install the fixed
connection. We recommend installing a residual-current
circuit breaker (RCCB) in the appliance's power supply
circuit.
5Installation
P reparing the installation
I n s t a l l a t i o n
Caution!
Ensure that there are no electric wires, gas or water
pipes in the area where holes are to be made.
Mark a vertical centre line on the wall from the
1.
ceiling to the lower edge of the extractor hood.
Mark positions for the screws and the contour of the
2.
attachment area.
Drill five 8 mm diameter holes to a depth of 80 mm
3.
for the attachments and press in the wall plugs flush
with the wall.
14
Installation
Screw on the fixing bracket for the flue duct.
1.
Screw on brackets for the extractor hood hand-tight.
2.
Do not firmly tighten the screws.
Screw in the threaded bolt, leaving it protruding out
3.
of the wall by 5–9 mm.
¨
©
ª
Advertisement
Table of Contents
