Operating The Appliance - Bosch DWA097E51A Instructions For Installation And Use Manual

1Operating the appliance

T hese instructions apply to several appliance variants.
O p e r a t i n g t h e a p p l i a n c e
It is possible that individual features are described
which do not apply to your appliance.
Switch on the extractor hood when you start
Note:
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Control panel model 1
Control panel
Explanation
Fan on/off
%
- Reduce the fan settings/fan run-on time
+ Increase the fan settings/intensive setting 1, 2
Light on/off/dimming
B
Setting the fan
Switching on the appliance
Press the button.
%
■
The fan starts at setting
Press the + or - button to change the fan strength.
■
Switching off
Press the button.
%
■
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Press the + button when the fan is at setting
The intensive boost setting
button again activates the intensive boost
After approx. six minutes, the electronics automatically
reduce the fan to a lower setting . If you want to end the
intensive setting before the preset time expires, press
the - button until the required fan setting is reached.
Fan run-on time
Press the - button until
After approx. ten minutes, the fan switches off
automatically.
.
ƒ
„
is activated. Pressing the +
‚
setting.
ƒ
appears.
‚r
Lighting
The lighting can be switched on and off independently
of the fan.
Press the
Setting the brightness
Press and hold the
brightness is reached.
Saturation display
When the metal mesh grease filters or the activated
carbon filter are saturated, a signal sounds for approx.
4 seconds after the fan is switched off.
In addition, the corresponding symbol appears in the
display:
Metal mesh grease filter:
■
Activated carbon filter:
■
If you have not yet done so, the metal mesh grease
filters should be cleaned or the activated carbon filter
changed now.
For instructions on how to clean the metal mesh grease
filters, please refer to the section
maintenance
While the saturation displays are flashing, they can be
reset. To do this, press the – button.
Switching over the display for circulating-air mode
For circulating-air mode, the electronic control display
must be switched over accordingly:
The extractor hood must be connected and switched
■
off.
Press the
■
display for starter sets for circulating-air mode or
™#
'#
lights up.
Repeatedly press the button combination to switch
■
the electronic control display back to exhaust air
mode (
.
Audible signal
Switching on the acoustic signal
When the fan is switched off, press the
buttons at the same time for approx. three seconds. An
acknowledgement signal sounds.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
Operating the appliance en
button.
B
B button until the desired
#
'#
.
and - button at the same time until the
%
display for CleanAir circulating air modules
# display).
Cleaning and
and +
%
5