Table of Contents
Advertisement
Commissioning and configuring SIMATIC PCS 7 AS mEC RTX
9.8 How to set the network addresses of SIMATIC PCS 7 AS mEC RTX
Requirement
● You can access the Windows interface of the SIMATIC PCS 7 AS mEC RTX. Options:
– A Remote Desktop connection has been established via network connection 1 (plant
– You have connected a monitor, mouse and keyboard to the SIMATIC PCS 7 AS mEC
Procedure
1. Select the menu command Start > Settings > Control Panel > System.
The "System Properties" dialog box opens.
2. Open the "Computer Name" tab.
3. Click "Change".
The "Change Computer Name" dialog box opens.
4. Enter the desired name of the computer in the "Computer Name" input box.
5. Activate the "Workgroup" check box enter the corresponding name.
6. Click "OK".
A message dialog informs you that the changes only take effect after rebooting the PC.
7. Click "OK".
8. Click "Yes" in the "System Properties" dialog box.
The PC reboots.
The SIMATIC PCS 7 AS mEC RTX is assigned the computer name you have specified
following the automatic reboot.
Requirements for reestablishing Remote Desktop connections
Before reestablishing a Remote Desktop connection, you need to repair the connection table
on the engineering station.
You can find additional information in the section " How to meet the requirements for
reestablishing network connections (Page 106) ".
9.8
How to set the network addresses of SIMATIC PCS 7 AS mEC RTX
Introduction
In the following, you set up the access point of the PC stations.
Note
Perform the following tasks on the engineering station and the SIMATIC PCS 7 AS mEC RTX.
104
bus).
RTX.
Function Manual, 03/2015, A5E32711362-AC
BOX (V8.1)
Advertisement
Table of Contents
