Table of Contents
Advertisement
INTRODUCTION
Spare parts for Newage axles may only be obtained from the original equipment manufacturer and
not directly from Newage. Always quote your vehicle/machine serial number and axle serial number
– see section titled 'Identification'.
If possible, the repair/service should be carried out in a clean environment. Where this is not possi-
ble, and the work must be completed on site, appropriate measures must be taken to ensure that
dirt or foreign matter does not enter the unit. Newage axles are designed to operate in the arduous
conditions found in the construction industry; providing they are maintained regularly they will pro-
vide the service our customers expect from Newage products.
GENERAL DATA
Description
The 415 series axle is a double reduction unit featuring a Hydraulic Disc Braking system.
The 1st reduction Spiral Bevel Pinion and Crown Wheel driving a 4 Pinion Differential. Final drive is
transmitted via the 2nd reduction in-board Planetary Assemblies. The Axle Shafts are fully floating
(i.e. not subjected to wheel loads) with each Wheel Hub supported on opposed taper Roller Bear-
ings.
Specification
Overall Ratio
12.33:1
Input Flange
To suit Hardy Spicer 1310 Coupling
Wheel Fixing
6 studs: 3/4" x 16 UNF-3A on 222.25 mm (8.75") PCD
Dynamic Axle Load Rating
Maximum load rating 5200 Kg (11440 lbs) based on 1793.75 mm (70.62") wheel track
Service Brake
See Torque/Pressure Graph
Park Brake
Not Applicable.
Approximate weight
180 kg (397 lb) dry
Oil Capacity
6.5 litres (11.4 Pints)
5
Advertisement
Table of Contents
