Servicing And Repairs; Seals; Bearings; Cleaning - PRM NEWAGE 415 Series Workshop Manual

SERVICING AND REPAIRS

WAR WARNING: Before carrying out any service work always ensure that the engine is switched off
Before removal of the Axle for repair or overhaul, carefully study the following procedures. Use proper hand
tools, slings and hoists for the job. WORK SAFELY
Keep all work areas, tools and Axle clean. All oil should be drained into a suitable container. Wipe up any
spilled oil or fluids to prevent accidents. Wear correct safety equipment I.e. safety glasses and safety shoes
to guard against personal injury
IMPORTANT NOTICE: ONLY REMOVE BREATHER, OIL
DRAIN PLUG OR OIL LEVEL PLUG ONCE THE AXLE IS AT
AMBIENT TEMPERATURE. REMEMBER HOT OIL CAN
CAUSE BURNS – WORK SAFELY.
CAUTION: The above operations should be carried out by suitably qualified personnel and
strictly in accordance with the procedures detailed in the workshop manual.
Drawings showing all internal components are contained in the parts lists at the back of this manual.

Seals

Remove Oil Seals carefully to prevent damage if they are to be re-used, however to prolong the life
of the axle, it is best to replace these items.

Bearings

If removing taper roller Bearings for re-use keep them in matched sets and protect all Bearings from
contamination.

Cleaning

WARNING: If using cleaning solvents these can be toxic, flammable, a skin irritant or give off
harmful fumes. Avoid prolonged contact, vapour inhalation, or smoking. Failure to take care
can result in injury or death.
Rinse all metal parts in solvent to remove dirt, grease and oil.
Be careful to remove solvent from items before re-fitting.
10