Sony CDP-CX57 Operating Instructions Manual page 21

1
Press MEGA CONTROL on this player.
The MEGA CONTROL button and "2nd" in the
display light up. The display shows the current
disc number or disc memo of the second player.
ALL DISCS
CD1
2nd DISC
* D I S C - 4 *
Current disc number or the Disc Memo
2
Press PLAY MODE to select the play mode you
want.
To program tracks, use the controls on the second
player.
You cannot change the second CD player's ALL
DISCS Play mode to 1 DISC Play mode, and vice
versa, by using the PLAY MODE button on this
player.
3
Press · on this player to start playing.
The play starts and the display shows the current
disc and track numbers and the playing time of the
track.
While the MEGA CONTROL button is lit, you can
control the second player with the controls on this
player.
To control the second player directly using the supplied
remote
Set CD 1/2/3 on the remote to CD 3 which is the same
position as the COMMAND MODE selector on the rear panel
of the second player.
To control this player again
Press MEGA CONTROL. The MEGA CONTROL button goes
off and you can control this player.
Loading the Disc Memos of the second CD
player
If the second CD player has the Disc Memo function
(see page 24), you can load the Disc Memos of the
second CD player to this player's memory and display
them on this player.
1
Press INPUT.
2
Turn the JOG dial until "LOAD 2ND MEMO"
appears in the display.
ALL DISCS
CD1
L O A D 2 N D M E M O
3
Push the JOG dial.
This player starts loading. (Loading takes about
one minute.)
Note
If each Disc Memo of the second CD player has more than 13
4
characters, the first 13 characters of each are loaded to this
player.
Labeling discs of the second CD player
You can label discs of the second CD player or change
the Disc Memos loaded from the second CD player.
1
Press MEGA CONTROL.
The MEGA CONTROL button lights up.
2
Turn the JOG dial to select the disc you want to
assign a Disc Memo to, then push the JOG dial.
If the disc slot you select does not have any disc,
"NO DISC" appears in the display and you cannot
assign a Disc Memo.
3
Press INPUT.
"DISC MEMO" appears.
4
Push the JOG dial.
5
Input the new Disc Memo following the procedure
in "Labeling Discs" on pages 24 to 26.
Note
The new Disc Memos are stored on this player's memory, so
you cannot display them on the second CD player.
Playing CDs
Getting Started Playing CDs
21