Connecting The Cables; Connecting The Power Cord; Connecting To The Computer - Roland DWX-4W Setup Manual

Hide thumbs Also See for DWX-4W:

Table of Contents

Connecting the Cables

WARNING

Important

The machine must be connected to the computer after the Windows driver has been installed.

Use a USB cable to connect the machine to a computer. Do not connect the machine to the computer yet. Be

sure to connect according to the instructions on P. 40 "Installing the Software". If the machine is connected

before the driver has been installed, driver installation may fail, and it may not be possible to use the machine.

Important

The machine ID needs to be changed when connecting more than one machine.

If you connect more than one unit of this machine to a single computer, be sure to follow the procedure given on P.

50 "Connecting Multiple Units". Connecting before changing the ID may render the machine unusable.

2. Installation and Setup

Connect to an electrical outlet that complies with this machine's ratings

(for voltage, frequency, and current).

Incorrect voltage or insufficient current may cause fire or electrical shock.

Handle the power cord, plug, and electrical outlet correctly and with care.

Never use any damaged article.

Using a damaged article may result in fire or electrical shock.

When using an extension cord or power strip, use one that adequately

satisfies the machine's ratings (for voltage, frequency, and current).

Use of multiple electrical loads on a single electrical outlet or use of a lengthy

extension cord may cause fire.

Connect to ground.

This can prevent fire or electrical shock due to current leakage in the event of

a malfunction.

Connect to an electrical outlet. Never connect directly to a power distribu-

tion panel or other such fixed wiring equipment.

Doing so increases the risk of fire or electrical shock.

Power outlet

Power cord

Table of Contents