Playing Discs In A Group (Block Play) - Sony CDP-CX225 Operating Instructions Manual

Playing Discs in a Group
(Block Play)
You can classify discs in advance by artists, category,
etc. when inserting discs into the slots, and play them
only within the group (called "block") you specified.
The player has eight blocks, and each slot is assigned to
one of the blocks as shown below.
Block number Disc slot
1
1–25
2
26–50
3
51–75
4
76–100
5
101–125
6
126–150
7
151–175
8
176–200
You can enjoy Continuous, Shuffle or Repeat Play
within a certain block.
POWER
BLOCK 1–8
Number
buttons
·
1
Insert discs into the slot of the block you want,
referring to the table. (See also "Inserting CDs" on
page 6.)
2
Press one of the BLOCK 1–8 buttons to select the
block.
When using the remote, press BLOCK, the number
button of the block you want, then ENTER.
The block number appears in the display.
3
Press ·.
Block Play starts from the disc which is the most
upward number within a block and located closest
to the playing position.
You can start Block Play from the disc you want
When you want to start Block Play from the disc you
want, turn the JOG dial to select the disc, then press
ENTER.
To cancel Block Play
Press the corresponding BLOCK 1–8 button.
Note
The block number does not appear if no disc is put into the
block you specified.
·
BLOCK
ENTER
Playing CDs
Getting Started Playing CDs
15