Playing In A Group (Block Play) - Sony CDP-CX681 Operating Instructions Manual

Playing CDs
Checking the programmed order
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the display shows the
disc and track number of each step in the programmed
order. (When a whole disc is programmed as one step,
"AL" appears instead of the track number.) After the
last step in the program, the display shows "End" and
returns to the original display.
Changing the programmed order
You can change your program before you start playing.
To
Erase a track or disc
Erase the last track or
disc in the program
Add tracks or discs to the
end of the program
Erase the whole program
completely
Erasing the program stored in memory
1
Press PROGRAM in the stop mode.
2
Hold down CLEAR until "All Clr" appears in the
display.
14
You need to
Press CHECK until the track or
disc you do not want appears in
the display, then press CLEAR
Press CLEAR. Each time you
press the button, the last track or
disc will be cleared.
Follow the programming
procedure
Hold down CLEAR until "All
Clr" appears in the display to
erase the whole program, then
create a new program following
the programming procedure
Playing Discs in a Group
(Block Play)
You can classify discs in advance by artists, category,
etc. when inserting discs into the slots, and play them
only within the group (called "block") you specified.
The player has eight blocks, and each slot is assigned to
one of the blocks as shown below.
Block number Disc slot
1 1–25
2 26–50
3 51–75
4
76–100
5
101–125
6
126–150
7
151–175
8
176–200
You can enjoy Continuous, Shuffle or Repeat Play
within a certain block.
BLOCK 1–8 ·