TECHNICAL DETAILS PARTS LIST SPARES LIST WARRANTY INFORMATION MODEL 7072 & 7073 Gas Salamander Grill The products stated above are designed and built to comply with the following standards: BS EN 203-1 BS EN 203-2-7 The products have been CE-marked in compliance with the European Gas Directive (90/396/EEC) www.parry.co.uk...
To avoid scratching the highly polished exterior surface of this equipment whilst in transit, the protective film on the exterior surfaces has NOT been removed. It is IMPORTANT that this protective film is peeled off before the equipment is used. www.parry.co.uk...
CEILING/SHELF 900mm REAR 75mm SIDES 75mm The appliance must be fitted securely on a non-combustible shelf or surface. Parry sell a wall shelf, bench stand and floor stand to accompany these units All local fire regulations should be observed. www.parry.co.uk...
To turn burner off, turn knob in clockwise direction a slight stop will be felt when back to pilot position, press in slightly to turn to off. We advise this appliance should not be left unattended when switched on. This appliance is for use by qualified people only, There are no user serviceable parts. www.parry.co.uk...
1 minute per side. Parry recommend that the maximum load, in respect of the loading of accessories used with the 7072 and 7073 Salamander Grills is a total of 20KG Operators should take care to systematically check and clean the cooking zone in particular the grill pan and receptacles before lighting to avoid the risk of fire.
Page 7
Reassemble in reverse order. Check for gas soundness and correct operation of flame failure unit. Refit side panel and flue cover. PLEASE NOTE: IF THE BURNER PLAQUES ARE CRACKED THEY WILL NOT BE COVERED BY WARRANTY www.parry.co.uk...
Replace the existing labels with NAT labels provided. Re-assemble in reverse order (5-1) Connect to gas, and soundness test Model Injector Code Butane G30 @28mbar 11.2” W.G. 7072 INJECT119 Propane G31 @ 37mbar 14.8” W.G. Nat Gas G20 @ 20mbar 8” W.G. 7072 INJECT193 Nat Gas G25 @ 25mbar 10”...
INSTRUCTION REF: IN146-7 DATE - 25/02/16 PAGE 12 of 14 Parts List *Metal work components IDENT DESCRIPTION 7072 7073 *Drip Tray Branding Plate PLBR00001 PLBR07074 Handle HAND01306 HAND01306 Handle HAND01306 HAND01306 *Grill Pan Crumb Tray Assembly Grill Pan Grid TRWG00001...
Page 13
It’s vital that all warranty requests be submitted to Parry via email to warranty@parry.co.uk It is at the discretion of PARRY whether to honour a service call which is out of the warranty period. Not Covered Under Warranty •...
Page 14
6 burner cooker. • Excessive carbon build up on griddle plates. • Over use of lava rock on the chargrills recommended use by Parry 2kg only. • Faulty electrics – eg, customers plug socket, plug, wiring, junction box fault, wrong fuse.
Need help?
Do you have a question about the 7072 and is the answer not in the manual?
Questions and answers