Ricoh P800 User Manual page 116

5. Troubleshooting
Message
"Cannot connect with DHCP
server.(101/201)"
"Cannot print."
"Change (Tray name) to the
following settings:"
"Check network settings.
(103/203)"
"Classification Code Error"
"Connect
failed:WirelessCard Turn
power off, check card."
"Cover Open. Please close
the indicated cover."
"Duplex mode is in off
position for (tray name)"
"Ethernet Board Error"
"Exceeded max. No. of
files."
114
Cause
An IP address cannot be obtained
from the DHCP server.
The machine cannot print the sent
data.
The size of the paper in the tray
does not match the paper size
specified in the printer driver.
The IP address setting is incorrect.
A classification code is not
specified for the print job.
The machine cannot detect the
wireless LAN interface board.
A cover of the machine is open.
The duplex mode for the indicated
tray is not available.
An error on the Ethernet is
detected.
While printing a Sample Print,
Locked Print, Hold Print, or Stored
Print file, the maximum file
capacity was exceeded.
Solution and reference
Consult your network
administrator.
Check that the file you want to
print is a supported file type.
Check the misfeeds and ask your
network administrator for help.
Select a tray containing paper
that is the same size as the
specified paper size.
Check the IP address, subnet
mask, and gateway address.
Enter a classification code using
the printer properties and print the
document again.
Check that the board is supported
or installed correctly.
Close the cover as indicated on
the control panel.
You can use one-sided printing
only. Press [Change] to change
the tray's settings, press [JobReset]
to reset the job, or press [Form
Feed] to force printing.
Turn the machine off, and then
turn it on again. If the problem
persists, consult your sales or
service representative.
Delete unneeded files stored in
the machine.