Setting The Clock - Sony 3-287-077-14(2) Operating Instructions Manual

Speaker pads
Attach the supplied speaker pads to the
bottom of the front speakers and
subwoofer to prevent slipping.
Front speakers:
4 pads for each speaker
Subwoofer:
4 pads (MHC-GT555, MHC-GT444 and
LBT-ZT4 only)
To use the remote
Slide and remove the battery
compartment lid, then, insert the two
supplied R6 (size AA) batteries, E side
first, matching the polarities shown
below.
Notes
• With normal use, the batteries should last for
about six months.
• Do not mix an old battery with a new one or
mix different types of batteries.
• If you do not use the remote for a long period
of time, remove the batteries to avoid damage
from battery leakage and corrosion.

Setting the clock

You cannot set the clock in Power Saving
Mode.
Use the buttons on the remote for this
operation.
1
Press "/1 to turn on the system.
2
Press CLOCK/TIMER SET
(RM-AMU006) or TIMER MENU
(RM-AMU008).
If "PLAY SET" appears on the
display, press ./>
(RM-AMU006) or
(RM-AMU008) repeatedly to select
"CLOCK SET" and then press
ENTER (RM-AMU006) or
(RM-AMU008).
3
Press ./> (RM-AMU006) or
V v
/ (RM-AMU008) repeatedly to
set the hour, and then press
ENTER (RM-AMU006) or
(RM-AMU008).
4
Use the same procedure to set
the minutes.
The clock settings are lost when you
disconnect the power cord or if a
power failure occurs.
To display the clock when the
system is turned off
Press DISPLAY repeatedly until the clock
is displayed. The clock is displayed for
about 8 seconds.
V v
/
15 GB