Preparation - Panasonic ER-SB60 Operating Instructions Manual

Preparation

Charging
• Turn the appliance off.
• Wipe off any water droplets on the appliance socket and the
charging stand.
1
Connect the appliance plug to the
appliance socket.
2
Plug in the adaptor into a
household outlet�
• Check that the charge status lamp (
glows.
• Charging is completed after approx. 1 hour.
3
Disconnect the adaptor after charging is completed�
While charging
The charge status lamp (
glows.
The battery capacity lamp will
blink in order of "LOW", "MID",
and "HIGH" while the charging
progresses.
ER-SB60_ME.indb 9
)
1
After charging is completed
) The battery capacity lamp and
the charge status lamp (
will light up and then turn off
after 5 seconds.
Notes
• If there is noise from the radio or other sources while using or
charging the appliance, move to a different location to use the
appliance.
• The battery will deteriorate if not used for over 6 months, so
make sure to perform a full charge at least once every 6 months.
• The charging time may differ when using the appliance for the
first time, or if it has not been used for more than 6 months. The
lamp on the appliance may not glow for several minutes when
first starting charging, but will glow when continuing to charge.
• Recommended ambient temperature for charging is
10 °C – 35 °C. It may take longer to charge, or the charge status
2
lamp ( ) will blink quickly and the battery may fail to charge
properly in extremely high or low temperatures.
• When the charge status lamp (
second), there is a charging malfunction. Please charge the
battery in the recommended ambient temperature range.
• 1 full charge will provide approximately 60 minutes of continuous
operation. (Based on dry using at 20 °C – 30 °C)
The operating time may differ depending on the frequency of use
and the operating method.
• The battery used is a lithium‑ion, so charging after every use will
have no effect on battery life.
Charging with the charging stand
1. Insert the appliance plug into the charging
stand.
2. Place the main body on the charging stand.
)
3. Plug in the adaptor into a household outlet.
) is blinking rapidly (twice every
3
2
1
9
6/22/2017 1:36:25 PM