Specifications - Sony STR-DG810 Operating Instructions Manual

Specifications

AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Models of area code U, CA
Minimum RMS Output Power (8 ohms, 20 Hz –
20 kHz, THD 0.09%)
100 W + 100 W
Stereo Mode Output Power (8 ohms, 1 kHz,
THD 1%)
110 W + 110 W
Surround Mode Output Power
THD 10%)
150 W/ch
1)
Measured under the following conditions:
Area code Power requirements
U, CA 120 V AC, 60 Hz
2)
Reference power output for front, center, surround
and surround back speakers. Depending on the
sound field settings and the source, there may be
no sound output.
Frequency response
Analog 10 Hz – 70 kHz,
+0.5/–2 dB (with sound
field and equalizer
bypassed)
1)
2)
(8 ohms, 1 kHz,
Input
Analog Sensitivity: 500 mV/
50 kohms
S/N
(A, 500 mV
Digital (Coaxial) Impedance: 75 ohms
S/N: 100 dB
(A, 20 kHz LPF)
Digital (Optical) S/N: 100 dB
(A, 20 kHz LPF)
Output (analog)
AUDIO OUT Voltage: 500 mV/10 kohms
SUB WOOFER Voltage: 2 V/1 kohm
Equalizer
Gain levels ±10 dB, 1 dB step
3)
INPUT SHORT (with sound field and equalizer
bypassed).
4)
Weighted network, input level.
FM tuner section
Tuning range 87.5 – 108.0 MHz
Antenna FM wire antenna
Antenna terminals 75 ohms, unbalanced
Intermediate frequency
10.7 MHz
AM tuner section
Tuning range
Area Tuning scale
code 10 kHz step
U, CA 530 – 1,710 kHz
Antenna Loop antenna
Intermediate frequency
450 kHz
5)
You can change the AM tuning scale to 9 kHz or
10 kHz. After tuning in any AM station, turn off
the receiver. While holding down TUNING
MODE, press ?/1. All preset stations will be
erased when you change the tuning scale. To reset
the scale to 10 kHz (or 9 kHz), repeat the
procedure.
3)
: 96 dB
4)
)
9 kHz step
5) 5)
531 – 1,710 kHz
continued
91 US