Sony STR-DG810 Operating Instructions Manual page 33

Sony operating instructions multi channel av receiver str-dg810
Hide thumbs Also See for STR-DG810:
Table of Contents

Advertisement

When you select "PHASE"
You can check the phase of each speaker (in
phase/out of phase).
Press V/v repeatedly to select a
speaker, then press
step 2 in "Confirming/saving the
measurement results".
Display
Explanation
xxx
* IN
The speaker is in phase.
xxx
* OUT
The speaker is out of phase. The
"+" and "–" terminals of the
speaker may be connected the
other way around. However,
depending on the speakers,
xxx
"
display even though the speakers
are connected properly. This is
because of the speakers'
specifications. In this case, you
can continue to use the receiver.
* xxx represent a speaker channel
FL
Front left
FR
Front right
C
Center
SL
Surround left
SR
Surround right
SB
Surround back
SW
Sub woofer
Tip
Depending on the position of the sub woofer, the
measurement results for polarity may vary.
However, there will be no problems even if you
continue to use the receiver with that value.
to return to
* OUT" appears on the
A. CAL menu parameters
You can use the A. CAL menu to make
settings for the Auto Calibration function to
suit your preference.
Select "8-A. CAL" in the amplifier menus. For
details on adjusting the parameters, see
"Navigating through menus" (page 39) and
"Overview of the menus" (page 40).
x AUTO CAL (Auto Calibration on/
off)
• A.CAL NO
The Auto Calibration function is turned off.
• A.CAL YES
The Auto Calibration function start.
x CAL TYPE (Calibration type)*
• ENGINEER
Sets the frequency characteristics to a set
that matches that of the Sony listening room
standard.
• FLAT
Makes the measurement of frequency from
each speaker flat.
• FRT REF
Adjusts the characteristics of all the speakers
to match the characteristics of the front
speaker.
x CAL LOAD (Preset measurement
loading)*
• LOAD YES
Select this when you want to load the saved
Auto Calibration result.
• LOAD NO
Select this when you do not want to load the
saved Auto Calibration result.
* You can select this parameter only when you have
performed the Auto Calibration and saved the
settings.
33
US

Advertisement

Table of Contents
loading

This manual is also suitable for:

Str dg810 - 6.1 channel home theater receiver

Table of Contents