Sony STR-DA5ES Primary Operating Instructions Manual page 84

Troubleshooting (continued)
To connect an LD player via an RF demodulator
• Connect the LD player to the RF demodulator,
then connect the RF demodulator's optical or
coaxial digital output to the receiver's DVD/LD
OPTICAL IN or COAXIAL jack. When making
this connection, be sure to set INPUT MODE
manually (see page 27). The receiver may not
operate correctly if INPUT MODE is set to
AUTO 2CH.
For details on DOLBY DIGITAL RF hookups,
see the operating instructions supplied with your
RF demodulator.
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied) to
connect the receiver to an outdoor FM antenna as
shown below. If you connect the receiver to an
outdoor antenna, ground it against lightning. To
prevent a gas explosion, do not connect the
ground wire to a gas pipe.
Outdoor FM antenna
Radio stations cannot be tuned in.
• Check that the antennas are connected securely.
Adjust the antennas and connect an external
antenna if necessary.
• The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use
direct tuning.
• Make sure you set the tuning interval correctly
(when tuning in AM stations with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the stations (see
page 45).
• Press DISPLAY so that the frequency appears in
the display.
There is no picture or an unclear picture appears
on the TV screen or monitor.
• Select the appropriate function on the receiver.
• Set your TV to the appropriate input mode.
• Move your TV away from the audio components.
84
Receiver
ANTENNA
75 COAXIAL
FM
U
AM
Ground wire
(not supplied)
To ground
Remote control
The remote does not function.
• Point the remote at the remote sensor
the receiver.
• Remove any obstacles in the path between the
remote and the receiver.
• Replace all the batteries in the remote with new
ones, if they are weak.
• If the receiver's COMMAND MODE and the
remote's COMMAND MODE do not match,
transmission is not possible between the remote
and the receiver.
• Make sure you select the correct function on the
remote.
• When you operate a programmed non-Sony
component, the remote may not function
properly depending on the model and the make
of the component.
When using RM-US105, the buttons for the tuner
operation do not work.
• The command mode of the remote is set to "2nd
room" or "3rd room". Set the command mode
correctly.
The component names appearing in the function
list do not correspond to the jacks on the
receiver./The sound field list does not appear.
• The remote has not been initialized. Turn on the
receiver, point the remote at the receiver, and
press SOUND FIELD, FUNCTION, or SUB on
the remote (see page 54).
E appears in the display window of the remote.
• The batteries are running out. Replace all the
batteries with new ones.
The function names that appear in the display
windows of the receiver and the remote are
different.
• Select the correct function using the remote.
When the CD player, tape deck, or MD deck is
connected to the receiver via CONTROL A1/A1
jacks, Auto Function does not work properly.
• Reprogram the remote (see page 64).
on