Sony STR-DA5ES Primary Operating Instructions Manual page 70

Using the lists (continued)
To download CD disc names (memos)
and information on the presence or
absence of a CD in each slot of a CD
changer
This function is available only when the
category for the CD function in the IR SET
list is set to "CD2" or "CD3". When the
category is set to "CD1", CD DISC NAME
does not appear in the DOWNLOAD list.
1 Move the easy scroll key to select "CD
DISC NAME" then press the key to enter
the selection.
The SORT menu appears in the display.
p
2 Move the easy scroll key to select
"NUMBER" or "ALPHABET", then press
the key to enter the selection.
The remote starts to download the data.
xxx
p
To cancel the downloading process
Move the easy scroll key to select "Exit" from
the DOWNLOAD list, then press the key to
enter the selection.
Notes
• If you have changed the discs in the CD changer, be
sure to download the CD disc names (memos) from
the receiver or play the newly inserted disc(s)
before you select a disc from the changer.
• You can download the data only from the Sony CD
changer (5, 50, 200, 300, or 400 discs) connected to
the receiver using the CONTROL A1 cable.
• CD DISC NAME is available for up to 400 discs.
70
Note on downloading CD disc names
from the CD players
You can download CD disc names (memos) only
from the CONTROL A1/A1 -compatible Sony CD
players. Depending on the CD player setting, it
may take several minutes to download CD disc
names (memos). For faster transmission, make the
following CD player settings.
When an CONTROL A1/A1 -compatible
Sony CD player is connected to the
receiver
Set the category for the CD function in the IR SET
list to "CD1". When using the Sony CD changer,
set it to "CD2" (or "CD3"). Be sure to set the
category to only one of "CD1", "CD2" or "CD3".
You can check the current category setting by
selecting a component from the function list (see
page 64).
When multiple CONTROL A1/A1 -
compatible Sony CD players are connected
to the receiver
When you use two CD players, set the
COMMAND MODE selector on the back panel of
the CD players to "CD1" or "CD2," respectively,
and set the category in the IR SET list to match the
corresponding player's COMMAND MODE
selector position (see page 64). When you use
three CD players, set the COMMAND MODE
selector to "CD1," "CD2," or "CD3," respectively,
and set the category in the IR SET list to match the
corresponding player's COMMAND MODE
selector position.
When using the Sony CD changer, be sure to set to
"CD2" or "CD3".
When setting category for the CD players, do not
skip the number or select the same number to the
multiple players.
When an CONTROL A1/A1 -compatible
Sony CD player and a non-compatible Sony
CD player are connected to the receiver
Set the COMMAND MODE selector on the back
panel of the CONTROL A1/A1 -compatible CD
player to "CD2" and set the category in the IR SET
list for the player to "CD2" (see page 64).
Set the COMMAND MODE selector on the back
panel of the non-compatible CD player to "CD1"
and set the category in the IR SET list for the
player to "CD1" (see page 64).
When using a non-Sony CD player in
conjunction with Sony CD players
Program the remote to control the non-Sony CD
player (see page 64).
See the sections above for settings of the Sony CD
players.