Sony STR-DA5ES Primary Operating Instructions Manual page 41

Initial settings
Parameter
TEST TONE*
PHASE NOISE*
PHASE AUDIO*
FRONT L__I__R
SURROUND L__I__R
SUR.BACK L__I__R
CENTER LEVEL
SURROUND LEVEL
SUR.BACK LEVEL
S.WOOFER LEVEL
LFE MIX LEVEL
D.RANGE COMP.
* One of these parameters appears depending on the
test tone mode (T.TONE) parameter in the SET UP
menu (page 50).
Test tone (TEST TONE)
Lets you output the test tone from each speaker
in sequence. When set to "AUTO", the test
tone is output from each speaker automatically.
When set to "FIX", you can select the speaker
to output the test tone.
Test tone (PHASE NOISE)
Lets you output the test tone from two adjacent
speakers at a time in sequence.
Test tone (PHASE AUDIO)
Lets you output the source sound instead of the
test tone from two adjacent speakers at a time
in sequence.
Front balance (FRONT)
Lets you adjust the balance between front left
and right speakers.
Surround balance (SURROUND)
Lets you adjust the balance between surround
left and right speakers.
Surround back balance (SUR.BACK)
Lets you adjust the balance between surround
back left and right speakers when surround
back L/R speakers are set to "YES".
Center level (CENTER LEVEL)
Lets you adjust the level of the center speaker.
Initial setting
OFF
Surround level (SURROUND LEVEL)
OFF
Lets you adjust the level of the surround left
OFF
and right speakers.
Center
Surround back level (SURR BACK
Center
LEVEL)
Center
Lets you adjust level of the surround back (left
0 dB
and right) speaker(s).
0 dB
Sub woofer level (S. WOOFER LEVEL)
0 dB
Lets you adjust the level of the sub woofer.
0 dB
LFE (Low Frequency Effect) mix
0 dB
level (LFE MIX)
OFF
Lets you attenuate the level of the LFE (Low
Frequency Effect) channel output from the sub
woofer without effecting the level of the bass
frequencies sent to the sub woofer from the
front, center or surround channels via the
Dolby Digital or DTS bass redirection
circuitry.
• For LFE mix level, "0 dB" outputs the full LFE
• To mute the sound of the LFE channel from the
signal at the mix level determined by the
recording engineer.
sub woofer, select "OFF". However, the low
frequency sounds of the front, center, or
surround speakers are output from the sub
woofer according to the settings made for each
speaker in the speaker setup (page 20–21).
continued
41