Bryant Legacy Line Series Manual page 30

PERFORMANCE DATA (CONT)
STATIC PRESSURE ADDERS (IN. WG) (FACTORY OPTIONS AND/OR ACCESSORIES)
CFM
VERTICAL ECONOMIZER
HORIZONTAL ECONOMIZER
NOTE: All above data for both standard and ultra low leak models, where availble.
STATIC PRESSURE ADDERS (IN. WG) (FACTORY OPTIONS AND/OR ACCESSORIES)
CFM
PERFECT HUMIDITY™
STATIC PRESSURE POWER EXHAUST PERFORMANCE (IN. WG) (FACTORY OPTIONS AND/OR ACCESSORIES)
RETURN DUCT STATIC PRESSURE (IN. WG)
VERTICAL POWER EXHAUST CFM
CFM 600
MEDIUM
GAS HEAT 0.005
DEDUCTION
LOW GAS
HEAT 0.012
DEDUCTION
General Fan Performance Notes
1. Interpolation is permissible. Do not extrapolate.
2. External static pressure is the static pressure difference between the return duct and the supply duct plus the static pressure
caused by any FIOPs or accessories.
3. Tabular data accounts for pressure loss due to clean filters, unit casing, and wet coils. Factory options and accessories may add
static pressure losses. Selection software is available, through your salesperson, to help you select the best motor/drive combi-
nation for your application.
4. The Fan Performance tables offer motor/drive recommendations. In cases when two motor/drive combinations would work,
Bryant recommends the lower horsepower option.
5. For information on the electrical properties of Bryant motors, please see the Electrical information section of this book.
6. For more information on the performance limits of Bryant motors, see the application data section of this book.
7. The EPACT (Energy Policy Act of 1992) regulates energy requirements for specific types of indoor fan motors. Motors regu-
lated by EPACT include any general purpose, T-frame (three-digit, 143 and larger), single-speed, foot mounted, polyphase,
squirrel cage induction motors of NEMA (National Electrical Manufacturers Association) design A and B, manufactured for
use in the United States. Ranging from 1 to 200 Hp, these continuous-duty motors operate on 230 and 460 volt, 60 Hz power. If
a motor does not fit into these specifications, the motor does not have to be replaced by an EPACT compliant energy efficient
motor. Variable speed motors are exempt from EPACT compliance requirements. Therefore, the indoor fan motors for Bryant
582J*04-06 units are exempt from these requirements.
30
600 800
0.012 0.020
0.018 0.026
600 800 1000
0.023 0.033 0.042
0.0
3239
STATIC PRESSURE DEDUCTIONS (IN. WG) (GAS HEAT OPTIONS)
800 1000
0.009 0.014
0.023 0.037
3 TO 5 TONS
1000 1250 1500
0.030 0.046 0.066
0.037 0.053 0.073
3 TO 5 TONS
1250 1500
0.054 0.067
3 TO 5 TONS
0.1 0.2
2974 2642
3 TO 5 TONS
1250 1500
0.023 0.034 0.046
0.060 0.088 0.122
1750 2000
0.089 0.115
0.096 0.124
1750 2000
0.080 0.093
0.3 0.4
2244 1780
1750 2000 2250
0.061 0.077
0.161 0.206
2250 2500
0.145 0.179
0.154 0.189
2250 2500
0.106 0.120
0.5
1249
2500
0.096
0.256