Advertisement
®
Z8 Encore! XP
F0822 Series Flash MCU Evaluation Kit
–
Evaluation Kit User Manual
–
Programmer's Reference Sheet
–
eZ8 CPU User Manual
–
Product Specification
–
Product Briefs
–
Application Notes
–
Flyers
–
Product Line Card
Supported Host Environments
The following system configurations are required on the host PC:
•
Microsoft Windows
SE
•
Pentium II/233 MHz processor or higher up to Pentium IV, 2.8 GHz
•
96 MB RAM or more
•
25 MB hard disk space or more
•
Super VGA video adapter
•
CD-ROM drive for software installation
•
One or more RS-232 communication ports
Setting up the Evaluation Board
The PC communicates with the Z8 Encore! XP F0822 Series Flash MCU evaluation board
using the serial port of the PC. A Z8 Encore! Smart Cable converts the RS-232 signals into
the 3.3 V bidirectional open-drain signal needed to communicate with the On-Chip
Debugger of the eZ8.
Always use a grounding strap to prevent damage resulting from
Caution:
electrostatic discharge (ESD).
Follow the steps below to setup the Z8 Encore! XP F0822 Series Flash MCU evaluation
board:
1. Connect the serial port of the PC to the Z8 Encore! Smart Cable DB-9 connector.
2. Connect the Z8 Encore! Smart Cable to the Z8 Encore! XP F0822 Series Flash MCU
evaluation board pin header P2.
3. Connect the power supply to the evaluation board at J1 (see
QS002507-1207
®
XP SP1, Windows 2000 SP3, Windows NT 4.0 SP6, Windows 98
Figure
1).
Page 2 of 9
Advertisement
