Table of Contents
Advertisement
1. Fill port
2. Dipstick
4.
Unscrew the dipstick and wipe the end clean
(Figure
9).
5.
Slide the dipstick fully into the fill port
without threading it into the port.
6.
Remove the dipstick and look at the end. If the
engine oil level is low, slowly pour only enough
oil into the fill port to raise the level to the Full
mark on the dipstick
7.
Install and secure the dipstick.
Checking the Gearcase Oil
Level
Service Interval: Before each use or daily
1.
Position the machine on a level surface.
2.
Set the Dyna-Clutch lever to the S
shut off the engine, and wait for all moving parts
to stop.
3.
Look at the sight glass in the gearcase plug
(Figure
10). The oil level should be 3/4 full.
Figure 9
3. Oil-level upper limit
4. Oil-level lower limit
(Figure
(Figure
9).
position,
TOP
g019746
If the oil level is not correct, refer to
Gearcase Oil (page
Cleaning Debris from the
9)
Machine
Service Interval: Before each use or daily
1.
Set the Dyna-Clutch lever to the S
shut off the engine, wait for all moving parts to
stop, and shut off the engine.
2.
Brush dirt and debris away from the air cleaner
and engine openings.
Folding and Unfolding the
Handle
1.
Turn the handle-adjustment knob
counterclockwise to loosen the handle.
2.
Place the handle to the desired position and turn
the handle-adjustment knob clockwise to tighten
the handle
10
Figure 10
Servicing the
17).
(Figure
11).
g021590
position,
TOP
Advertisement
Table of Contents
