Table of Contents
Advertisement
The edges of the appliance in contact with the door joint
are warm
Especially during summer (warm seasons), the surfaces in contact
with the door joint may become warmer during the operation of the
compressor, this is normal.
There is a build-up of humidity inside the appliance
Check if:
• All food is packed properly. Containers must be dry
before being placed in the freezer.
• The freezer doors are opened frequently. Humidity of
the room will enter the freezer each time the doors
are opened. Humidity increases faster if the doors are
opened frequently, especially if the humidity of the
room is high.
• There is a build-up of water droplets on the rear wall.
This is normal after automatic defrosting (in Static
Models).
The doors are not opening or closing properly
Check if:
• There is food or packaging preventing the door from
closing
• The door compartments, shelves and drawers are
placed properly
• The door gaskets are broken or torn
• Your freezer is level.
Recommendations
To stop the appliance completely, unplug from main socket
(for cleaning and when the door is left open)
Important:
n
n
In the case of a power failure, or if the appliance is unplugged
and plugged in again, the gas in the cooling system of
your refrigerator will destabilise, causing the compressor
protective thermal element to open.
Your freezer will start to operate normally after 5 minutes.
If the appliance will not be used for a long period of time
(such as during holidays), disconnect the plug. Defrost and
clean the refrigerator, leaving the door open to prevent the
formation of mildew and odour.
If the problem persists after you have followed all the
instructions above, please consult the nearest Authorised
Service Centre.
This appliance is designed for domestic use and for the stated
purposes only. It is not suitable for commercial or common
use. If the consumer uses the appliance in a way that does
not comply with these instructions, we emphasise that the
manufacturer and the dealer will not be responsible for any
repair or failure within the guarantee period.
Tips for saving energy
1.
Install the appliance in a cool, well ventilated room, but
not in direct sunlight and not near a heat source (such
as a radiator or oven) otherwise an insulating plate
should be used.
2.
Allow warm food and drinks to cool before placing them
inside the appliance.
3.
Drinks or other liquids should be covered when inside
the appliance. If left uncovered, the humidity inside the
appliance will increase, therefore the appliance uses
more energy. Keeping drinks and other liquids covered
helps preserve their smell and taste.
4.
Avoid keeping the doors open for long periods and
opening the doors too frequently as warm air will enter
the appliance and cause the compressor to switch on
unnecessarily often.
5.
The door gasket must be clean and pliable. Replace
gaskets if worn.
15
Advertisement
Table of Contents
