Tuning To Preset Stations; Naming Preset Stations - Sony 4-168-043-14(1) Operating Instructions Manual

Tuning to preset stations

1
Press TUNER repeatedly to
select the FM or AM band.
2
Press PRESET + or PRESET –
repeatedly to select the preset
station you want.
Each time you press the button, you can
select a preset station as follows:
1 2 3
30 29
You can also press and hold SHIFT and
then press the numeric buttons to select
the preset station you want. To enter the
selection, press and hold SHIFT then
press ENTER.
Using the controls on the
receiver
1
Turn INPUT SELECTOR to select the FM
or AM band.
2
Press TUNING MODE repeatedly to select
"PRESET".
3
Press TUNING + or TUNING – to select the
preset station you want.

Naming preset stations

1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Tune in the preset station you
want to create an index name
for (page 41).
3
Press AMP MENU.
4
Press V/v repeatedly to select
"TUNER", then press
4 5 ... 27
28
or b.
5
Press V/v repeatedly to select
"NAME IN", then press
The cursor flashes and you can select a
character.
6
Press V/v to select a character,
then press B/b to move the
cursor to the next position.
If you made a mistake
Press B/b until the character you want to
change flashes, then press V/v to select
the correct character.
Tips
• You can select the character type as follows
by pressing V/v.
Alphabet (upper case) t Numbers t
Symbols
• To enter a blank space, press b without
selecting a character.
7
Press .
The name you entered is registered.
Note (Models of area code ECE, CEK,
AU1 only)
When you name an RDS station and tune in that
station, the Program Service name appears instead
of the name you entered. (You cannot change the
Program Service name. The name you entered will
be overwritten by the Program Service name.)
or b.
41 GB