Specifications; Troubleshooting Guide - Sony 4-168-043-14(1) Operating Instructions Manual

If you are unable to remedy the
problem using the

troubleshooting guide

Clearing the receiver's memory may remedy
the problem (page 30). However, note that all
memorized settings will be reset to their initial
settings and you will have to readjust all
settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields

Specifications

AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U2 only)
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 90 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Models of area code U2
Minimum RMS Output Power
(8 ohms, 20 Hz – 20 kHz, THD 0.09%)
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
See
page 30
Surround Mode Output Power
page 46
(8 ohms, 1 kHz, THD 10%)
Models of area code CA2, ECE, CEK, AU1
Minimum RMS Output Power
(8 ohms, 20 Hz – 20 kHz, THD 0.09%)
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
Surround Mode Output Power
(8 ohms, 1 kHz, THD 10%)
1)
Measured under the following conditions:
Area code
U2, CA2
ECE, CEK, AU1
2)
Reference power output for front, center and
surround speakers. Depending on the sound field
settings and the source, there may be no sound
output.
1)
90 W + 90 W
100 W + 100 W
2)
130 W per channel
1)
85 W + 85 W
100 W + 100 W
2)
130 W per channel
Power requirements
120 V AC, 60 Hz
230 V AC, 50 Hz
continued
75 GB