Ingersoll-Rand PROMAXX MX60-SD Maintenance Information
Hide thumbs
Also See for PROMAXX MX60-SD:
- Product information (21 pages) ,
- Instruction manual (22 pages)
Related Manuals for Ingersoll-Rand PROMAXX MX60-SD
Summary of Contents for Ingersoll-Rand PROMAXX MX60-SD
- Page 1 51998342 Edition 2 March 2008 PROMAXX™ Spike Driver Models MX60-SD and MX90-SD Maintenance Information Save These Instructions...
-
Page 2: Maintenance
WARNING Always wear eye protection when operating or performing maintenance on this tool. Always turn off the air supply and disconnect the air supply hose before installing, removing or adjusting any accessory on this tool or before performing any maintenance on this tool. Note: When reading the instructions, refer to exploded diagrams in parts Information Manuals when applicable (see under Related Documentation for form numbers). -
Page 3: Inspection And Repair
Inspection and Repair Check the valve chest assembly (7) for cracks or chipping. If DANGER damaged, replace it. Replace the piston (4) when a .007 in. (.178mm) feeler gauge can When using any solvent to clean parts, make sure that it meets be inserted between the piston and the housing bore. -
Page 4: Troubleshooting Guide
Troubleshooting Guide Trouble Probable Cause Solution Plugged exhaust port or air passages Dismantle spike driver, clean out all ports and air passages. Keep the caused by dirt or hose particles. air hose in good condition; never use a soft deteriorated hose. Stuck valve due to gummy oil or Remove valve chest assembly from the spike driver. - Page 5 Notes:...
- Page 6 Notes:...
- Page 7 Notes:...
- Page 8 © 2008 Ingersoll Rand Company...
Need help?
Do you have a question about the PROMAXX MX60-SD and is the answer not in the manual?
Questions and answers