Sony DSR-2000P Operating Instructions Manual page 140

Troubleshooting
Alarm message on monitor screen
Cause
A cleaning tape has been inserted.
A non-standard signal is being used for
input video.
A non-standard ref. signal is being used for
REF. VIDEO.
Abnormal settings selected in setup menu.
Audio mixing mode cannot be changed
during recording.
Audio not editable on this tape.
Audio REC mode selection different from
audio on tape.
Audio REC (recording) mode cannot be
changed during recording.
Cassette adaptor not usable.
Counter mode is selected.
Input selection cannot be changed in REC
(recording) mode.
Input signal does not conform to DVCAM/DV
format.
Input signal is 625/50. (For DSR-2000)
Input signal is 525/60. (For DSR-2000P)
Input video is not detected.
Input video signal does not synchronize with
REF. VIDEO signal.
Key inhibit mode is selected.
Moisture has been detected.
No cassette in VTR.
Rec inhibit mode is selected.
Record inhibit plug on the cassette is set to
inhibit.
140
Chapter 8 Maintenance and Troubleshooting
Alarm messages and associated directions
Direction
The tape will automatically be ejected after cleaning
is completed.
Use a standard signal.
Use a standard signal.
Correct the setup menu settings. Contact your
Sony dealer if this alarm message appears again
after making corrections.
—
Use a tape recorded in 2-channel (48 kHz) or
4-channel (32 kHz) mode.
Use a tape having audio signals recorded in locked
mode.
Select the same audio recording mode as that of
the tape.
—
Use a tape without cassette adaptor.
Use the COUNTER SEL button to light the TC or U-
BIT indicator in the display section.
—
—
—
—
Check the INPUT VIDEO indication in the input
selection/audio mode display section and supply an
appropriate video signal.
Use a common reference signal or connect the
recorder REF. VIDEO OUT connector to the player
REF. VIDEO IN connector.
Note
When connecting the recorder REF. VIDEO OUT
connector to the player REF. VIDEO IN connector,
set extended menu item 308 to N-STD.
Set the KEY INHIBIT switch on the subsidiary
control panel to OFF.
Keep the power on and wait until this alarm
message disappears.
Load a cassette.
Set the REC INHIBIT switch on the subsidiary
control panel to OFF.
Set the REC/SAVE switch on the cassette to REC.
Alarm message in the
diaplay section
Cleaning Tp
VIN NON-STD
REF NON-STD
ILL. SETUP
REC mode!
2CH/32kHz!
Fs 44.1kHz!
UNLOCK mode
A mode err
REC mode!
Adaptor!
CNT mode!
REC mode!
Unknown Sig
625/50 sig! (For DSR-
2000)
525/60 sig! (For DSR-
2000P)
No INPUT!
ILL. REF!
KEY INHI.
HUMID!
No Cass.!
REC INHI.!
REC INHI.!
(Continued)