Basic Setup & Configuration - Electro Industries EM-MC00 Series Installation & Operating Manual

Basic Setup & Configuration
Fahrenheit/Celsius Selection – Labeled "°F °C" (J22). This jumper allows for selection of degrees
Fahrenheit or Celsius to be displayed on the display.
NOTE: Factory default is °F. A power down reset is required upon changing of this jumper.
Blower Speed Adjustment – the blue adjustment dial allows for fine tuning the blower speed. If you do
not need full CFM of your application and desire a larger temperature rise, the blower speed can be
reduced with this adjustment dial. However, you must realize the CFM is being reduced and you must
maintain the appropriate requirement for balancing the building inlet to the outlet mechanical driven air.
NOTE: Factory default setting is low, full counter-clockwise. To increase speed turn dial clockwise.
07/29/2019 14 EI915