Alexander Pedals was started for two reasons - to make great tones, and to do good. The great tones part you probably have some idea about. As for doing good, Alexander Pedals donates a portion of the profits from every pedal sold to charity, whether you buy from us or our dealers.
Yup. Maybe you want your stuff to sound like a cat on helium? Yes, we do that too. Basically, Marshmallow is a quick way to start at normal and end up at “what was that?!” We hope you like it as much as we do.
And ontrols Marshmallow does a lot of stuff, but that doesn’t mean that it’s hard to use! Generally you can just turn the knobs on the pedal and explore new sounds, but we put a few extra controls on the pedal that we think you can use.
Page 5
ounds And ontrols Continued RING (lower red) Twin pitch shifters with an adjustable fade / tremolo effect. Low settings of MOD sound like tremolo or panning, higher settings sound like robot barf. MAIN FUNCTIONS ALT FUNCTIONS PITCH 1/2 CLOCK PITCH 1 PITCH 2 BLEND RATE...
Presets to the rescue! Marshmallow and all of our other Neo Series pedals have built-in preset capability. That means you can save and recall four sounds from a single pedal with no extra hardware or funny business.
ettinG edAl Your Neo Series pedal has a few user settings stored in memory. These settings include the function of the MultiJack on the left side of the pedal, LED brightness, and others. DYNA RAND To enter setup, power on the pedal and then hold down the center Select button.
Marshmallow supports most types of expression pedals for performance control. We recommend the Roland EV-5 and Moog EP-3, but just about any expression pedal that uses a TRS cable should work. The supported expression wiring is SLEEVE = 0V, RING = 3.3V, TIP = 0-3.3V.
Marshmallow also supports our Neo Footswitch for preset Select or warp functions. To use the Neo Footswitch, you’ll need to configure Marshmallow to use its MultiJack for footswitch input. Consult the instructions on page 6, Setting Up Your Pedal.
Midi C onFiGurAtion All Neo Series pedals support full control using MIDI. In order to use your Marshmallow with a MIDI controller, you’ll need to follow these instructions to configure its MultiJack and set up the MIDI channel. First, you’ll need a way to connect your MIDI controller to the MultiJack.
MIDI Continuous Controller 59: Mode Select 3: RAND CLOUD 4: ARPY RING 5: DYNA Marshmallow does not respond to MIDI Beat Clock and does not have tap tempo capability. PeCiFiCAtions Input Impedance: 1M ohm Output Impedance: 560 ohm Power Supply:...
Need help?
Do you have a question about the Marshmallow and is the answer not in the manual?
Questions and answers