Saving The Camera Position Preset Position Setting Menu - Sony IPELA SNC-P5 User Manual

Saving the Camera
Position
— Preset position
setting Menu
When you click Preset Position of the Advanced mode
menu, the preset position setting menu is displayed. In
this menu, PanTilt and Zoom position can be saved up to
8 items, and the home position the camera faces to can
be saved when the power is turned on.
Preset
Preset No.
Select a preset number from 1 to 8 in the list box.
Recall: When you click Recall, the camera moves to the
position of the selected preset number at present.
Set: Use it to save the camera position to a preset
number.
Carry out the following steps.
1 Move the camera to the position to be saved while
you are checking the image with the main viewer.
2 Select a preset number for saving, and write the
preset position name.
3 Click the SET.
The camera position is saved.
Reset: When you press Reset, deletes the saved contents
of the current selected preset number.
Preset position name
Write the preset position name of the selected preset
number.
Position at alarm
The camera can synchronize the preset position with
Sensor input 1 or 2 or with the activity detection
function.
64
Saving the Camera Position — Preset position setting Menu
If an alarm is detected by the sensor input or the activity
detection function, the camera automatically moves to
the corresponding preset position.
Sensor input1: Select a preset position to synchronize
with the alarm from Sensor input 1.
Sensor input2: Select a preset position to synchronize
with the alarm from Sensor input 2.
Motion detection: Select a preset position to
synchronize with the alarm from the motion
detection.
In the case not to synchronize with any preset number,
select None.
Note
In the case that the synchronized preset position is
specified, the alarm event that happens during moving to
the preset position will be invalid.
Home position
Set the position the camera faces to when the power is
turned on.
Home position number
Select the preset number from 1 to 8.
When the power is turned on, the camera moves to the
preset position programmed to the selected preset
number.
Resume time on inactivity
The user operates PanTilt or Zoom, or selects whether
the camera returns to the home position after the preset
activity by the alarm.
On: You can specify in the text box the wait time before
the camera moves to the home position , from 5 to
600 seconds.
After the PanTilt operation or so of the user, the
camera returns to the home position automatically
after the specified time has elapsed.
Off: When the user has operated PanTilt or so, the
camera stays in the stop position and it does not
return to the home position.
Tip
When you click button on the control panel, the
camera moves to the preset position set in the home
position number.
Preset position table
The programmed preset position names are displayed.
OK/Cancel
See "Buttons common to every setting menu" on page
31.