Configuring Gvrp Timers - H3C S3100 Series Operation Manual

Operation Manual (For Soliton) – GVRP
H3C S3100 Series Ethernet Switches
Enable GVRP on the port
Note:
After you enable GVRP on a trunk port, you cannot change the port to a different
type.
Use the port trunk permit all command to permit the traffic of all dynamically
registered VLANs to pass through a trunk port with GVRP enabled.

1.2.3 Configuring GVRP Timers

Follow these steps to configure GVRP timers:
Enter system view
Configure the LeaveAll
timer
Enter Ethernet port view
Configure the Hold, Join,
and Leave timers
Note that:
The setting of each timer must be a multiple of 5 (in centiseconds).
The timeout ranges of the timers vary depending on the timeout values you set for
other timers. If you want to set the timeout time of a timer to a value out of the
current range, you can set the timeout time of the associated timer to another
value to change the timeout range of this timer.
The following table describes the relations between the timers:
To do ...
gvrp
To do ...
system-view
garp timer leaveall
timer-value
interface interface-type
interface-number
garp timer { hold | join |
leave } timer-value
Use the command ...
Use the command ...
1-6
Chapter 1 GVRP Configuration
Remarks
Required
By default, GVRP is
disabled on the port.
Remarks
—
Optional
By default, the LeaveAll
timer is set to 1,000
centiseconds.
—
Optional
By default, the Hold, Join,
and Leave timers are set
to 10, 20, and 60
centiseconds
respectively.