Replacement Parts - Pentair EVERPURE CONSERV LT-S Manual

High efficiency reverse osmosis (ro) processor

Hide thumbs

Table Of Contents

Table of Contents

Limited Flow at the Application Equipment Valve

1. Turn OFF water supply to processor.

2. OPEN the application valve to turn on flow.

3. Unscrew the blue cap on the side of the Storage Tank to

expose air valve. Use a small air compressor or bicycle

pump to slowly add air to the storage tank. This will

force the water out of the storage tank through the valve.

Continue to slowly add air until water stops coming out

of the valve.

4. Turn OFF the application equipment valve.

5. Using an air pressure gauge, adjust the pressure in the

storage tank to 5-7 psi (0.34 bar, 0.034 MPa).

6. Replace the blue cap.

7. OPEN the incoming water valve until it comes to a stop.

Let the processor run one (1) to three (3) hours to fill the

tank. A full tank weighs approximately 32 lbs (14.5 kgs)

pounds. If performance has not improved, call

Technical Support.

Sudden Return of Taste and Odor

If shortly after complete servicing, noticeable taste and odors

return, contact Technical Support.

NOTES

If you are experiencing a problem not listed in this manual,

shut OFF the water supply and CLOSE the tank valve. Call

Technical Support.

Check for compliance with state and local laws and

regulations.

Do not use with water that is microbiologically unsafe or of

unknown quality without adequate disinfection before or after

the system.

For installations in Massachusetts, the Commonwealth of

Massachusetts Plumbing Code 248 CMR shall be adhered

to. Consult your licensed plumber for installation of the

system. This system and its installation must comply with

state and local regulations.

Systems certified for cyst reduction may be used on

disinfected waters that may contain filterable cysts.

Substances that may be reduced are not necessarily in your

water. Filter must be maintained according to manufacturer's

instructions, including replacement of filter cartridges.

The efficiency rating for this system is 56.31%. Efficiency

rating means the percentage of the influent water to the

system that is available to the user as reverse osmosis

treated water under operating conditions that approximate

typical daily usage.

The tested recovery rating is 63.02%. Recovery rating means

the percentage of the influent water to the membrane portion

of the system that is available to the user as reverse osmosis

treated water when the system is operated without a storage

tank or when the storage tank is bypassed.

EVERPURE

CONSERV

LT-S HIGH EFFICIENCY RO SYSTEM INSTALLATION AND OPERATION GUIDE

Daily Production Rate: 70 gpd (265 Lpd).

This reverse osmosis system contains a replaceable

component critical to the efficiency of the system.

Replacement of the reverse osmosis component should

be with one of identical specifications, as defined by the

manufacturer, to ensure the same efficiency and contaminant

reduction performance.