Table of Contents
Advertisement
AQUADUCT
11. Mechanical fill level and flow indicator
All aquaduct variants have a mechanical fill level- as well as a flow indi-
cator. These are integrated into the two lateral aluminum profiles.
As you have read in the chapter about filling the system, the coolant is
filled into the right profile, seen from the front. In this profile you can see
a black ball from the side. This shows you the filling level. The filling lev-
el must be read
while the aquaduct is working
and should always be
over the middle of the profile.
In the left profile you can see a red ball which swims upwards when
switching on the aquaduct. This is driven up by a side-flow of the
coolant. This ball may be no longer visible in the operation of the sys-
tem.
Important: The flow indicator only shows a sufficient flow at the start of
the aquaduct. Should the flow sink or the circulation be disrupted later,
the indicator does not show this again. However, it is a very good indi-
cator, whether the ball valves of the aquaduct are open and no air is in
the system.
12. Electronic fill level and flow indicator (aquaduct 360
XT)
The electronic flow measurement measures precisely the flow of the sys-
tem. This is shown in the display and in the aquasuite software.
Since the used pumps produce a corresponding flow depending on the
fill level of the aquaduct and
their control
curve, it is possible with a spe-
cial measurement to draw conclusions on the filling level of the
aquaduct. After filling the aquaduct and after changes at the cooling
system a calibration of this measuring is necessary. After that the fill level
is measured at every start of the aquaduct and is shown on the display
as well as in the software.
- 24 -
Aqua Computer GmbH & Co. KG
© 2007
Gelliehäuser Str. 1, 37130 Gleichen
Advertisement
Table of Contents
