Preparation Before Operation - Mitsubishi Electric MFZ-KT25VG Operating Instructions Manual

O R T N NSTR T ONS
P
REPARATION BEFORE OPERATION
Remote controller
Operation
display section
Temperature
buttons
Operation
select button
ECONO COOL
button
i-save button
CLOCK button
RESET button
TIME, TIMER set buttons
Increase time / Decrease time
(ON timer) : The unit turns ON at the set time.
(OFF timer) : The unit turns OFF at the set time.
Press (Increase) and
of timer.
WEEKLY TIMER set buttons
Press to enter the weekly timer setting mode.
Press and to select setting day and number.
Press , , and to set ON/OFF, time, and tem-
perature.
Press to complete and transmit the weekly timer setting.
Press to turn the weekly timer ON. (
Press again to turn the weekly timer OFF. (
out.)
EN-4
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard from
the indoor unit when the
signal is received.
OFF/ON
(stop/operate) button
FAN speed control
button
VANE control button
TIME, TIMER set
buttons
Increase time
Decrease time
WEEKLY TIMER
set buttons
Lid
Slide the lid down
to open the remote
controller. Slide it down
further to get to the
weekly timer buttons.
(Decrease) to set the time
lights.)
goes
OFF/ON (stop/operate) button
Operation select button
(AUTO) (COOL) (DRY)
Temperature buttons
FAN speed control button
(AUTO) (Silent) (Low)
VANE control button
Press to select vertical air ow direction. Each
press will change air ow direction in the following
order:
(AUTO) (1) (2) (3)
• Two short beeps will be heard from the indoor unit when set to
AUTO.
• Moving the horizontal vane/multi-flow vane manually can cause
trouble.
• The horizontal vane/multi-flow vane automatically moves in certain
intervals to determine its position, and then it returns to the set posi-
tion.
When the air outlet is switched between 1 FLOW and 2 FLOW, the
horizontal vanes may move and change their positions.
VANE control button
Press to select the air outlet(s).
When 2 FLOW is selected, air blows from the top
and the front of the unit. When 1 FLOW is selected,
air blows only from the top of the unit.
(2 FLOW) (1 FLOW)
The multi-flow vane is automatically set to the appropriate position.
Even if 2 FLOW is selected, air will blow only from the top of the unit
in the following conditions:
• During COOL/DRY: The room temperature is close to set tempera-
ture. The air conditioner has operated for 0.5 to 1 hour.
• During HEAT: The air flow temperature is low.
(During defrosting operation, start of operation, etc.)
ECONO COOL button
The set temperature and the air ow direction are automatically
changed by the microprocessor.
i-save button
A simplifi ed set back function enables to recall the preferred
(preset) setting with a single push of the
the button again and you can go back to the previous setting
in an instance.
(HEAT) (FAN)
(Med.) (High)
(4) (SWING)
button. Press