Name Of Parts - Fujitsu ASWX18FAT Operating Manual

NAME OF PARTS

Fig. 1 Indoor Unit
Fig.2 Intake Grille
• Pull both ends of the grille towards you to
open it.
• Push down the grille and press the 4 locations
shown with the arrows.
Fig. 4 Indicator
Fig. 5 Outdoor Unit
En-3
(4-1) OPERATION Indicator (green)
OPERATION
TIMER
(4-2) TIMER Indicator (orange)
POWERFUL
(4-3) POWERFUL Operation Indicator (green)
(4-4) Remote Control Signal Receiver
(5-3) Pipe Unit
Intake Grille (Fig. 2)
(1-1) Air Cleaning Filter
• behind Air Filter.
• This part is optional for ASWX18FAT.
Operating Control Panel (Fig. 3)
(1-2) Front Panel
Indicator (Fig. 4)
(1-3) Air Flow Direction Louver
(1-4) Power Diffuser
(1-5) Right-Left Louver
• behind Air Flow Direction Louver.
(1-6) Air Filter
Fig.3 Operating Control Panel
(3-1) MANUAL AUTO button
• When kept on pressing the MANUAL AUTO button for more
than 10 seconds,the forced cooling operation will start.
• The forced cooling operation is used at the time of installation.
Only for authorized service personnel's use.
• When the forced cooling operation starts by any chance, press
the START/STOP button to stop the operation.
• If the TIMER indicator lamp fl ashes when the timer is operating,
it indicates that a fault has occurred with the timer setting
(See Page 16 Auto Restart).
(5-1) Air outlet (warm air is blown out)
(5-2) Air inlet (side and top panels)