Vemer FHT Series User Manual page 18

(16) if "yes" both key beep and alarm-condition buzzer are enabled. If "no" both are
disabled
(17) If "yes" the type of alarm is displayed even during timing of the same, if "no" the
type of alarm is displayed only after the timing
(18) if "yes", at the end of a min/max alarm it will be necessary to dismiss alarm type
reading and reset the relay manually
(19) if "yes", at the end of a min/max alarm it will be necessary to dismiss alarm type
reading manually (the relay will automatically reset instead)
(20) blocks the generation of max/min alarms for a period
[DSP] view menu
Confi gurable
parameter
labels
LO1
HI1
LO2
HI2
SOF
SIF
RIS
UNI
FIL
Note:
(21) parameter is active only if it applies to the operating mode
(22) value added to the measure to compensate for an inaccuracy of the same
(23) reading resolution:
0.1 if "HI" or 1.0 if "LO"
(24) Attention: when unit of measurement is changed, parameter settings are not
converted automatically and must be recalibrated.
(25) if the parameter is set to "yes" a moving average of 8 measurement values (i.e. of
about 4 seconds) is calculated, if "no" the average is not calculated
Description
lower limit of set-point 1
upper limit of set-point 1
lower limit of set-point 2
upper limit of set-point 2
probe 1 calibration offset
probe 2 calibration offset
reading resolution
temperature measurement unit
measurement fi lter
- 44 -
User Manual – Thermoregulator FHT
Parameter
unit value default notes
min max
degrees -99 HI1
degrees LO1 999
degrees -99 HI2
degrees LO2 999
degrees -50 +50
degrees -50 +50
- HI LO
- C F
- no yes
-99
999
-99 (21)
999 (21)
0.0 (22)
0.0 (22)
HI (23)
C (24)
yes (25)