Vemer FHT Series User Manual page 16

[OUT] output menu
Confi gurable
parameter
labels
ETR
DON
TOF
TON
INI
TCL
Note:
(5) this parameter enables the control of times set in DON, TOF, and TON for each
output as follows:
0 timing disabled for both relay outputs
1 timing enabled only for relay 1 output
2 timing enabled only for relay 2 output
3 timing enabled for both relay 1 and 2 outputs
(6) this parameter restricts the number of starts per hour for the equipment connected
to the device (parameter frequently used e.g. for compressors)
(7) minimum time in which output must remain ON
(8) minimum time in which output must remain OFF
(9) output activation delay time from reset of the device
(10) the period that can be set for PWM regulation. This reading is displayed only if the
operating mode selected is PRO=5 (see system menu).
[ING] outside input menu
Confi gurable
parameter
labels
TID
DID
SUI
Note:
(11) Confi gurable values are: 0 disabled
Description
relay time-
control activation
minimum time between
2 starts of same relay
minimum ON time
of relay
minimum OFF time
of relay
initial delay
from device start
PWM cycle time
Description
digital input function
digital input delay
output status with
dig. input enabled (open)
- 42 -
User Manual – Thermoregulator FHT
Parameter
unit value default notes
min max
- 0 0
min 0 200
min 0 200
min 0 200
min 0 200
sec 1 200
Parameter
unit value default notes
min max
- 0 4
min 0 200
- 0 3
3 (5)
0 (6)
0 (7)
0 (8)
0 (9)
200 (10)
0 (11)
0 (12)
0 (13)