Sony VPL-PX41 Operating Instructions Manual page 43

5
Insert the new lamp all the way in until
it is securely in place. Tighten the
screws. Fold up the handle.
Notes
• Be careful not to touch the glass surface
of the lamp.
• The power will not turn on if the lamp is
not secured properly.
6
Close the lamp cover and tighten the
screws.
Note
Do not tighten the screws too much. Doing
so could damage some of the internal
components of the projector.
7
Turn the projector back over.
8
Connect the power cord and turn the
projector to standby mode.
9
Press the following keys on the
control panel in the following
sequence for less than five seconds
each: RESET, <, ,, ENTER.
Caution
Do not put your hands into the lamp
replacement spot, or not fall any liquid or
object into it to avoid electrical shock or fire.
Disposal of the used lamp
For the customers in the USA
This product contains mercury. Disposal of
this product may be regulated if sold in the
United States. For disposal or recycling
information, please contact your local
authorities or Electronics Industries Alliance
(http://www.eiae.org).
Replacing the Lamp
43