Sony KP-XA43 Operating Instructions Manual page 8

Connecting a DVD player
Rear of TV
1
2
3
L
R
(MONO)
Connecting a DVD player with component video output connectors
Rear of TV
to
input) Y/C
Y
C /
B
B-Y
C /
R
R-Y
L
R
-L (white)
-R (red)
Notes
• Since the high quality pictures on a DVD disc contain a lot of
information, picture noise may appear. In this case, adjust the
sharpness (SHARP) in the VIDEO ADJUST menu. (See page 19.)
• Connect your DVD player directly to your TV. Connecting the
DVD player through other video equipment will cause unwanted
picture noise.
Connecting an amplifier with Dolby* Pro Logic decoder
Even though you use an amplifier with Dolby Pro Logic
decoder instead of the projection TV's audio system, you
can still use the projection TV's center speaker.
Rear of TV
C
8
-EN Getting Started
to ... 1, 2, or 3 (video input)
(yellow)
-L (MONO)(white)
-R (red)
(component video
/B-Y/C /R-Y
B R
COMPOMENT VIDEO OUT
Y
to component video
output
to (center speaker
inputs)
DVD player
LINE OUT
R-AUDIO-L VIDEO
to audio/
video
outputs
DVD player
S VIDEO OUT LINE OUT
C /B-Y C /R-Y R-AUDIO-L
B R
to audio output
• If your DVD player can output interlace and progressive mode
signals, select the interlace output when connecting to
(component video input) on your TV.
Your TV can receive either 525i/60 Hz or 625i/50 Hz interlace
signals.
* Manufactured under license from Dolby Laboratories
Licensing Corporation.
DOLBY, the double-D symbol a and "PRO LOGIC" are
trademarks of Dolby Laboratories Licensing Corporation.
Amplifier with Dolby Pro
Logic decoder
Rear
speaker
(L)
Front
speaker
(L)
: Signal flow
VIDEO
: Signal flow
Rear
speaker
(R)
Front
speaker
(R)