Setup; Ac Power; Fuse Replacement - Chauvet DJ Hurricane 1800 FLEX User Manual

Setup

3. Setup

AC Power

The Hurricane 1800 Flex has a fixed voltage power supply and it can work with an input voltage of either
120 VAC, 60 Hz or 230 VAC, 50 Hz, depending on the specific model.
To determine the product's power requirements (circuit breaker, power outlet, and wiring), use the current
value listed on the label affixed to the product's back panel, or refer to the product's specifications chart.
The listed current rating indicates the product's average current draw under normal conditions.
• Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or
fire.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.

Fuse Replacement

1. Disconnect the product from power.
2. Twist the fuse holder cap counterclockwise to loosen the fuse holder and pull straight out.
3. Remove the blown fuse.
4. Replace with a fuse of the same type and rating.
5. Screw the fuse holder back in place and reconnect power.
Spare fuse holder
(inside safety cap)
• Disconnect the product from the power outlet before replacing the fuse.
• Always replace a blown fuse with another of the same type and rating.
Hurricane 1800 Flex User Manual Rev. 1
Installed fuse
(held by plastic clip)
Safety cap
Page 5 of 18