Descaling The Appliance; Storage - Silvercrest SKML 1000 A1 Operating Instructions Manual

Descaling the appliance

Descale the appliance at regular intervals.
NOTE
► Depending on the hardness of your water, the necessary descaling
intervals may vary considerably. If your water is very hard, descaling is
generally necessary after approximately 30 uses, while less hard water
only requires you to descale your appliance after approximately 60 uses.
Your local water supplier can tell you about the hardness of your water.
Use only descaling agents that are specifically suitable for coffee machines and
follow their usage instructions closely.
Proceed as follows to descale:
1) Add the descaling agent to the water tank
2) Add the amount of water as specified in the usage instructions for the
descaling agent, but do not exceed the MAX mark (8 cups) on the fill level
indicator
3) Press the
4) Press the
lights up; the
5) Wait until enough water for approximately 2 cups has run through the
machine, then stop the brewing process by pressing the
6) Allow the descaling agent to take effect for 15 minutes.
7) Repeat steps 3 to 5 twice.
8) Then start the brewing process and wait until the water has run through
completely.
9) Allow the coffee machine to brew three times with the maximum amount of
clean water. After three brewing cycles, all residues of the descaling agents
are removed and you can use your coffee machine again.

Storage

■ If you do not intend to use the appliance for long periods, ensure that no
coffee grounds remain in the appliance.
■ Clean the appliance again as described in "Cleaning and care".
■ Place the mains cable into the cable storage compartment
■ Store the dry appliance in a clean and dust-free location.
■ 32 │ GB │ IE
!
button to switch off the grinder. The
button to start the brewing process. The light element
button flashes.
.
button lights up.
button
.
SKML 1000 A1
again.