Connecting Two Vcrs For Tape Editing - Sony KP 53HS10 Operating Instructions Manual

Connecting Two VCRs for
Tape Editing
SELECT OUT gives you the ability to use a
second VCR to record a program being played by
the primary VCR or to perform tape editing and
dubbing.
1
Connect the VCR intended for playback using
the connection instructions on page 9 of this
manual.
2
Using an AUDIO/VIDEO cable, connect
AUDIO and VIDEO IN on the VCR intended
for recording to AUDIO and VIDEO OUT of
SELECT OUT on the projection TV.
Notes:
• Do not change the input signal while editing
through SELECT OUT.
• When connecting a single VCR to the projection
TV: if VCR LINE OUT is connected to VIDEO IN
on the projection TV, do not connect the SELECT
OUT on the projection TV to the VCR LINE
INPUT (see right). Doing so will cause program
interference and other viewing problems.
• You can select the output signal from SELECT
OUT from the SET UP menu. (see "SELECT
OUT" on page 41)
16
S VIDEO
VIDEO
L
(MONO)
VCR (for playback)
AUDIO
R
AUDIO R AUDIO L VIDEO OUT
LINE
IN
OUT
1
VMC-810S/820S
(not supplied)
(Rear of projection TV)
VIDEO IN
Disconnect all power sources before making any connections.
(Rear of projection TV)
CONTROL S IN OUT
VIDEO 4 VIDEO 5 (DTV) SELECT
IN OUT
HD VD
IN
VIDEO 1 VIDEO 3
Y Y/G
VIDEO
L
(MONO)
P P /B
B B
L
AUDIO
P P /R R
R R
R
COMPONENT AUDIO
VIDEO VIDEO
AUDIO-L AUDIO-L
AUDIO-R
AUDIO-R
SELECT
OUT
Indicates direction
of signal
LINE
IN OUT
AUX
VHF/UHF
VCR (for recording)
AUDIO R AUDIO L VIDEO OUT
LINE
IN
IN
2
VMC-810S/820S
(not supplied)