Connecting A Dbs (Direct Broadcast Satellite) Receiver And Vcr - Sony KP 53HS10 Operating Instructions Manual

Connecting a DBS (Direct
Broadcast Satellite) Receiver
and VCR
1
Connect the cable from the satellite antenna to
the satellite receiver.
2
Attach the coaxial cable from the incoming
cable connection or antenna to VHF/UHF IN
on the VCR.
3
Using a coaxial cable, connect VHF/UHF
OUT on the VCR to VHF/UHF on the
projection TV.
4
Using AUDIO and S VIDEO* cables, connect
AUDIO and S VIDEO OUT on the DBS
receiver to AUDIO and S VIDEO IN on the
VCR.
5
Using AUDIO and S VIDEO* cables, connect
AUDIO and S VIDEO OUT on the VCR to
AUDIO and S VIDEO IN on the projection TV
(White-AUDIO Left, Red-AUDIO Right).
* If your VCR or DBS receiver is not equipped
with S VIDEO, use a VIDEO cable (yellow)
instead of the S VIDEO cable.
Note:
• To view input from the DBS or VCR, select the
video input which your DBS receiver or VCR is
connected to by pressing TV/VIDEO on the remote
control.
14
(Rear of projection TV)
CONTROL S
VIDEO 4
IN OUT
IN
VIDEO 1 VIDEO 3
S VIDEO
VIDEO
L
(MONO)
AUDIO
R
VIDEO
S
AUDIO-L
VIDEO
AUDIO-R
5
VMC-810S/820S (not supplied)
YC-15V/30V (not supplied)
Disconnect all power sources before making any connections.
AUX
IN OUT
SELECT
VIDEO 5 (DTV)
SATELLITE IN
HD VD
LINE OUT
VHF/UHF
Y Y/G
VIDEO
Satellite
L
P P /B (MONO)
B B
antenna
L
cable
AUDIO
P P /R R
R R
R
COMPONENT AUDIO
VMC-810S/820S
(not supplied)
Coaxial cable
(not supplied)
3
DBS
VHF/UHF
AUDIO R AUDIO L VIDEO
S VIDEO IN
OUT
1
YC-15V/30V
(not
supplied)
4
VCR
S VIDEO
AUDIO R AUDIO L VIDEO
LINE
IN
VHF/UHF
OUT
LINE
OUT IN
Cable/
Antenna
2