Step 2: Hookup - Sony KL-X9200J Operating Instructions Manual

Step 2: Hookup

Before making the connection, turn off the power and
disconnect the AC power cords of the monitor and the
equipment to be connected. Refer to the instruction
manual of the equipment you connect.
Connecting to an IBM PC/AT or
compatible computer
Connect the RGB 2 IN connector on the front or the
RGB 1 IN connector at the rear of the monitor to the
video output of the computer using the supplied RGB
signal cable (D-sub 15 pin ˜ D-sub 15 pin). Use an
audio connecting cord (not supplied) for the audio
connections.
Using the front RGB 2 IN connector
Front of the monitor
RGB signal cable
(supplied)
HD15–HD15 adaptor
(supplied)*
Male side
(without the No.9 pin)
to video output
IBM PC/AT or compatible
computer
RGB 2 IN
S VIDEO
RGB
AUDIO
or
Audio connecting
cord
(stereo miniplug ˜
stereo miniplug)
(not supplied)
to audio output
Using the rear RGB 1 IN connector
Rear of the monitor
RGB 1 IN
AUDIO
R L
RGB OUT
AUDIO
R L
Audio connecting
cord (phono plug
2 ˜ stereo
miniplug)
(not supplied)
to audio output
IBM PC/AT or compatible
computer
* The HD15–HD15 adaptor (supplied) may be needed for some
models. The male side (without the No. 9 pin) of the adaptor
should be connected to the computer.
For customers using the supplied HD15–HD15
adaptor
This monitor uses a No. 9 pin in the video signal
connector for DDC1 and DDC2B compatibility.
Some PC systems which are not compatible with either
DDC1 or DDC2B may not accept the No. 9 pin. If you
are not sure whether your PC system accepts the No. 9
pin or not, use the HD15 (Female) – HD15 (Male
without the No. 9 pin) adapter (supplied).
RGB
RGB
RGB signal cable
or
(supplied)
HD15–HD15 adaptor
(supplied)*
Male side (without
the No.9 pin)
to video output
7 -GB
Getting Started
GB