Advertisement
MITRE GUIDE (Figure 1)
The mitre guide has a variable setting between 0° and 45°. Loosen the knobs (5), set the mitre by tilt -
ing the table (1) up until you have reached the required tilt. Tighten the knobs (5) again on both sides
of the worktable.
CLEANING, MAINTENANCE AND REPAIR
Disconnect the mains plug after use, before cleaning, changing the cutting disc or the water tank.
Please clean the tool immediately after use:
1) Disconnect the plug from the socket.
2) Remove the water tray from the machine and drain the dirty water.
3) Unscrew the splash guard and clean it.
4) Loosen the star-shaped knob, fold up the table and polish the entire machine.
The machine complies with all current safety regulations. Repairs may only be carried out by an
approved company, because repair attempts by unqualified people may cause injuries to the user
and bystanders. Regularly check the plug and the cable and if they are damaged they must be re -
placed by an approved company. Also check any extension cables. Damaged safety guards and
switches must be replaced before the machine is used again.
CHECKING AND REPLACING THE DIAMOND BLADE
Cracked or distorted diamond blades must be replaced.
Type of disk: a diamond blade with a diameter of 180mm.
Do not use diamond blades that do not meet the specifications in these instructions.
The mains plug must be disconnected before changing the window pane or before carrying out
any adjustment or cleaning work.
Ensure that the diamond blade is secured properly and rotates in the correct direction.
To replace a worn disk, please take the following steps (fig. 2):
1) Disconnect the plug from the socket.
2) Remove the water tray (4, fig. 1) from the machine.
3) Loosen the splash guard's fixing bolts and remove the splash guard.
4) Loosen the blade fixing nut (4, fig. 2).
5) Remove the counter flange (3, fig. 2) and blade (2, fig. 2) and push the new blade on the
flange (1, fig. 2). Consider the rotation direction indicated on the blade. Attach the counter
flange (3, fig. 2).
6) Tighten the fixing nut (4, fig. 2) and the splash guard.
7) Ensure you do not leave any tools lying on the splash guard.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 15
Advertisement
