Advertisement
INSTALLING THE TILE CUTTER
The tile cutter may only be used as a fixed tool and should be screwed down to a level and hori-
zontal surface. Please use the screw holes in the base of the machine.
The electrical supply must be connected to a 230 V earthed wall socket. The mains voltage must
comply with the information on the type plate and must be protected by a circuit breaker.
Do not use the power cable to pull the plug from the socket. Protect the cable against heat, oil and
sharp objects.
Only use accessories and auxiliary equipment mentioned in the instructions for use or recom-
mended/Mentioned by the manufacturer. Using other accessories or auxiliary equipment may
carry a risk of injury for you and others.
OPERATION (Figure 1)
•
Before starting the job, please ensure there is sufficient water in the water tray (4) i.e. the diamond
blade runs through the water. During the job, the water tray must be topped up.
•
Do not start working before the maximum speed has been reached.
•
Diamond blades must NEVER be exposed to sideways pressure; they can break and flying pieces
become projectiles!
•
Do not attempt to cut extremely small pieces from the tiles. Always make sure that the full surface
of the tile is on the work table. The supplied mitre guide can be used to push the tiles through the
cutter. In the early stages of cutting in particular, the tile must remain absolutely level to avoid the
tile moving up.
•
Do not overload your tool. It is better and safer to work within the indicated power range. Do not
cut materials other than tiles.
•
Maintain your tools carefully. Keep the tools sharp and clean in order to work properly and safely.
Follow the maintenance instructions and the instructions for replacing the diamond blade.
•
Stand safely and maintain your balance. Avoid any unnatural body angles. Remain alert and pay
attention to your work. Use common sense. Do not use the machine when you cannot concentrate
or when you are tired.
FULL LENGTH ADJUSTABLE FENCE (Figure 1)
The fence (3) enables you to cut parallel to the cutting blade. Set up: Loosen the knobs (7) and set the
required distance. Tighten the knobs on both sides of the work table. The markers determine the mea-
surements (8).
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 14
Advertisement
