Simons Voss Technologies Z4.KA Quick Manual page 8

3. Installation Z4.KA &
Z4.KA.SET

3 Installation Z4.KA &
Z4.KA.SET
1. Dismount outside knob with the aid of the
2. Remove 0-ring on the core tube with a suitable
3. Apply adapter and turn while holding on to the
4. Insert the enclosed pin with the thinner side at
5. Fasten the pin with a suitable screwdriver.
6. Make sure that the pin does not protrude on any
7. Mount the outside knob with the aid of the
4 Installation Z4.MP.KA.SET
Freely rotating, digital locking cylinders only
(except AP2.FD).
1. Use the installation tool to remove the outer
8 / 32
No changes may be made to the core
protection adapter.
installation tool.
tool.
9 NOTE: The cylinder may not deform!
knob until it can be full pushed onto the core
tube.
The cross hole of the adapter is flush with
9
the cross hole of the core tube.
the front of the side through the adapter hole
on which the thread is to be seen.
NOTE: The thread may not be destroyed.
9
side of the adapter.
installation tool.
thumb-turn.
Z4 (.MP) .KA (.SET)
EN