On Transporting The Printer; Cleaning - Sony UP-DR100 Instructions For Use Manual

On Transporting the Printer

Do not transport the printer with the supplied
accessories attached. Doing so may cause a malfunction.

Cleaning

Note
Be sure to turn off the power of the printer before
cleaning it.
When the cabinet becomes dirty
Clean the cabinet, panel and controls with a soft dry
cloth, or a soft cloth lightly moistened with a mild
detergent solution.
Do not use any type of solvent, such as alcohol or
benzine, which may damage the finish.
After you replace the paper roll with the
new one
After you spent one paper roll and load the new one,
perform the following cleaning.
Note
Be sure to use the printer only after it has been dried
completely, if you intend to use the printer just after you
have cleaned it. If it has not been dried completely, this
may have an influence on the quality of the printout.
To clean the thermal head:
Clean the thermal head heating elements, IC cover and
ribbon guide gently with a soft cloth.
Thermal head heating elements
Ribbon guide
To clean the platen roller:
Clean the platen roller gently with a soft cloth moistened
with alcohol.
To clean the pinch roller:
Clean the pinch roller gently with a soft cloth moistened
with alcohol while turning the pinch roller.
To clean the cleaning roller for the ink ribbon:
Clean the cleaning roller gently with a soft cloth
moistened with alcohol to remove the dust accumulated
IC cover
on the roller.
Clean the platen roller gently with a soft cloth
moistened with alcohol while turning the platen roller.
Pinch roller
21
Precautions