Fidelis Network Integration - Enterprise Commandpost Environments; Fidelis Network Integration - Fidelis Network Cloud Environments - Fidelis Direct/Internal 10G Quick Start Manual

4. Use these credentials at the login prompt:
−
user: fidelis
−
default password: fidelispass
5. From the command line, run: sudo /FSS/bin/setup
You will be prompted for the SU (fidelis) password
6. Within Setup, select Network Settings.
7. Configure the network parameters for the system and each active network interface.
a. Use the Network Configuration table you prepared earlier.
b. When complete, return to the top menu.
8. When complete, select [OK] to leave Setup.
9. From command line, reboot the system: sudo /fss/bin/shutdown.pl --user admin --reboot
8. Fidelis Network Integration — Enterprise CommandPost
Environments
Register Sensor Appliances with Your Fidelis Enterprise CommandPost
1. Log into the CommandPost GUI from a web browser.
2. Navigate to the System > Configuration Wizard page.
3. Click [Add] Sensor. Complete the form:
−
Component Name — this is a user-friendly name for the Sensor, not the FQDN of the Sensor
−
Component IP address — the IP address of the ADMIN interface of the Sensor appliance
−
Description — an optional label for the component e.g. location, business unit, etc.
−
click [Add].
4. The Sensor's Component Name will appear on the list below Direct/Internal. Click on the
Component Name to view the Component Details.
5. Click [Register] and accept the End User License Agreement (EULA). CommandPost will
then communicate with the Sensor at the specified IP address.
9. Fidelis Network Integration - Fidelis Network Cloud
Environments
Register Sensor Appliances with Fidelis Network Cloud
Please contact Fidelis Support to connect your Sensors to the Fidelis Network Cloud. Fidelis
Support will work with you to configure the Sensors and enable the Fidelis Network Cloud for your
environment.
©Fidelis Cybersecurity
Fidelis Network™ Sensor Appliances
9
QUICK START GUIDE
www.fidelissecurity.com