Appliance - Logical Network Configuration - Fidelis Direct/Internal 10G Quick Start Manual

ILO / IPMI Network
Optional network for remote/out-of-band server administration. You will need one additional switch
port for each IPMI connection.
Appliance
All Sensors
5. Appliance — Logical Network Configuration
Each physical connection must be assigned logical network information. Build a table of the logical
information for each appliance (example below) that you can reference during configuration.
Appendix A includes a worksheet for you. You will reference this table multiple times during setup.
Direct/Internal Sensor Appliances With 10GbE Optical Ports
Network Setting
Interface
Hostname (FQDN)
Static IP Address
Subnet Mask 255.255.255.0
Gateway
Proxy Server
DNS Servers
NTP Servers
Time Zone
*For Alternative Sensor Network Configurations - In-line & ERSPAN
This Quick Start Guide will help you configure a Sensor in "tap" or "out-of-band" mode, where each
monitoring interface is connected to a different network. In out-of-band mode, each monitor port is
configured in promiscuous mode, and therefore do not need IP network information. Sensors may
alternatively be configured in-line with the network traffic or support ERSPAN, which may require IP
network configuration. For help with these configurations, please see the Fidelis Network
Enterprise Setup Guide.
©Fidelis Cybersecurity
Switch Port Type
8P8C "RJ45" (copper)
Admin Prevent
10.1.2.3 172.16.1.254
255.255.255.0
10.1.2.1 172.16.1.1
Fidelis Network™ Sensor Appliances
Assignments
Mon-A Mon-B Mon-C
sensor1.myorganization.int
n/a* n/a* n/a*
n/a* n/a* n/a*
n/a* n/a* n/a*
10.5.6.7
8.8.4.4, 8.8.8.8
0.pool1.ntp.org.
UTC (+0)
7
QUICK START GUIDE
Qty.
Mon-D ILO / IPMI
n/a* 10.2.3.4
n/a* 255.255.255.0
n/a* 10.2.3.1
www.fidelissecurity.com